EP4 Solid Profile Woodworking Cutters & Heads

EP4 cutters give a long economical life with high production runs between regrinds. Cutting and clearance angles give clean finishes at high production outputs. The clamping system employed gives the cutter accurate and rigid location in the cutter head.

Cutters are hardened, tempered and ground all over to close tolerances. The cutter heads are fine machine finished all over to similar tolerances. Close tolerances on the cutters and heads, together with a ground form profile, ensures accurate location and uniformity of the finished product.

High quality material at the correct hardness ensures long production runs between regrinds. This, together with the large number of regrinds possible, ensures maximum economic cutter life. Accurately finished cutters and cutter head pockets allow for rapid profile changes with minimum machine down time and fewer heads are required for a larger range of profiles.

Sharpening

For best results, a proper tool and cutter grinder should be used for sharpening woodworking cutters. To ensure maximum accuracy, they should be ground in the head normally operated in. Grinding of the cutters should be done systematically, and only be carried out on the cutting face. On no account should the pattern section be ground or ‘touched up’.

Click on the link below to download the brochure

EP4 Solid Profile WOODWORKING CUTTERS & HEADS Brochure

EP4 Solid Profile Woodworking Cutters & Heads
EP5 & EP7 Solid Profile Woodworking Cutters & Heads
EP6 Finger Joint Cutter With Replaceable Knives
Planing & Profiling Heads
CONTACT US

Email: info@we-can.co.nz
Phone : + 64 6 879 7561

Fax : + 64 6 879 7147

Terms & Conditions | Disclaimer | Privacy Policy 
We Can Precision Engineering
Copyright 2017